Set up your tool paths.
The smoke screen is .75" you can buy them on Amazon.

You can duplicate the SVG to cut more than one Smoker at a time. The design is meant to be cut as follows.
1st cut a pocket from the top of the stock down to .25" leaving the Center Smoke stack alone.
2nd. Cut the pocket for the Center Stack
3rd Cut the small pocket for the Smoke Screen.
4th Cut the Smoke stack hole all the way through the piece.
5. Cut any Text you like
6. Cut the profile cut.
I did not add any tabs, so if you need tabs please add them. I suggest using the blue tape and CA glue method for holding the stock to the CNC bed.